WT4-AXB - Factory Test Print Mode

Problem/Question

How to check printer setting via factory test print mode. 

Applicable To

WT4-AXB

Resolution/Answer

Steps for Test Print Using the Shortcut Button
1. Turn off the printer.
2. Load media and ribbon.
3. Press and hold the Left button while turning on the power.

4. Release the Left button When “SELF-TEST …” is displayed on the LCD.
5. The printer will print a configuration report, as shown in the example on the next
page. All characters will be printed in 2 columns: the right shows characters received
from your system, and the left shows the corresponding hexadecimal values of the
characters. It allows users or engineers to verify and debug the program.

Steps for Test Print via LCD Menu
1. Turn on the printer.
2. At this stage, the printer screen will display the following interface:

3. Press the Middle button, then press and hold it again.
4. The printer screen will now display the following interface:

5. Use the arrow keys to navigate to the Tools menu

6. Press the ENTER button.

7. Use the arrow keys to navigate to the Test Print option.

8. Press the ENTER button to print a configuration report.

After printing the self-test page, you can view the printer's configuration settings. The self-test page provides valuable information about the printer's current setup, allowing you to
verify and ensure that the printer is functioning correctly and set up to meet your specific
needs. The printed settings typically include details as follows:

The figure below shows the configuration label.
￭ SBPL

03-80236-EN