The icons on the screen indicate the current state of the product.
Only a limited number of icons can be displayed on the screen. Therefore, important icons have priority over the other icons.
Current state of the product
|
|
|
|
|
The product is in stopped state. (Offline) |
|
|
The product is receiving data. |
|
|
The product is printing. (Online) |
|
|
The product has stopped printing. (Offline) |
|
|
The product is waiting for dispenser. This icon only appears if you have selected the [Dispense Mode] (PW208NX only) or the [Linerless] operation mode. |
|
|
HEX dump mode is enabled. This icon only appears if you have selected [Enabled] in the HEX dump mode. |
Interface Information
|
|
|
|
|
|
|
This icon appears when the USB port is in use. |
|
|
|
Bluetooth is available but not connected. |
|
|
|
Bluetooth is available and connected. |
|
|
|
Wi-Fi is available but not connected. This menu only appears if the product supports wireless LAN. |
|
|
|
This menu only appears if the product supports wireless LAN. |
|
|
|
This menu only appears if the product supports wireless LAN. |
|
|
|
This menu only appears if the product supports wireless LAN. |
|
|
|
This menu only appears if the product supports wireless LAN. |
|
|
|
This icon appears when Wi-Fi Direct is enabled. This menu only appears if the product supports wireless LAN. |
|
|
|
This icon appears when a USB memory is connected. |
|
|
|
|
|
|
|
|
|
|
|
|
-: Enlarged icon is not displayed.
|
|
|
|
|
Status Icons
|
|
|
|
|
|
|
|
|
The remaining battery level is displayed. When the Eco Charge function is set to [Disabled], different information is displayed depending on the battery level. The remaining battery level is also displayed in a numeric value (%) on the left side of the icon. |
|
|
|
|
|
The battery is being charged using the AC adapter. When the Eco Charge function is set to [Disabled], different information is displayed depending on the battery level. The remaining battery level is also displayed in a numeric value (%) on the left side of the icon. |
|
|
|
|
|
The battery cannot be charged due to the internal temperature of the product being too high or too low. |
|
|
|
|
|
Please replace the battery if  or  is displayed. |
|
|
|
|
|
A receive buffer near full warning was detected. The receive buffer is almost full. Please wait until the icon disappears. |
|
|
A command error was detected. The print data may be incorrect. Please check the print data. |
|
|
There is a broken element in the print head. A head error may be displayed depending on the print layout. |
|
|
IP address could not be acquired. Reconfigure your network connection and settings, and restart the product once the network settings are displayed correctly. |
|
|
Authentication with iOS has been aborted. Wait until the icon disappears (approx. 130 sec.) and then re-authenticate with iOS. Do not power off the product or remove the battery while the authentication with iOS is in progress. |
|
|
Bluetooth connection with iOS cannot be established due to failure of the authentication chip. Please contact the SATO technical support. |
|
|
The product information could not be sent to the SOS. |
|
|
|
|
|
The product is due for cleaning. |
|
|
The print head or platen roller is due for replacement. |
