[01-01006-EN] Parts Identification (Internal View)

Applicable models: CT4-LX

 

(1) Print head (Consumables)

Creates an image on the media. Clean the print head regularly.

(2) USB connector (Type A)

You can use USB memory to automatically back up setting information by using the auto-clone function.

The connector is on the underside of the top cover. Pull out the parts (3), on which  are engraved, inside the top cover, remove the cover that is held by screws, and then insert the USB memory.

 

Be sure to perform a virus check on the USB memory before connecting it to the product. SATO Corporation shall not be held responsible for any product malfunctions caused by a virus spread via USB memory.

	The size of the USB memory that can be connected inside the product is as follows:
	Length: under 68 mm (2.68") (excludes the metal part of the connector) Width: under 27.6 mm (1.09") Thickness: under 8.6 mm (0.34")

(3) Engraved 

Indicated by the  (ribbon cover open) marks on the combined direct thermal/thermal transfer model.

(4) Media guide

(5) Platen roller (Consumables)

(6) Top cover