[02-00118-EN] Adjusting the Product

Applicable models: CL4NX/6NX Plus
Please refer to the below.

Printable Area

Media Sensor Positions and Media Stop Positions

The flow of Printing Operations

• Printing Operations
• Operations in Continuous Mode
• Operations in Tear-Off Mode
• Operations in Cutter Mode
• Operations in Dispenser Mode
• Operations in Linerless Mode (CL4NX Plus Only)
• Operations for RFID Write (RFID Models Only)
• Operations When the Barcode Check Function Is Enabled
• Operations When the Media Sensor Is Disabled

Adjusting the Base Reference Point

• About the Base Reference Point
• Adjusting the Print Position
• Adjusting the Media Stop Position
• Notes on the Stop/Cut Position of Different Media
  

Adjusting the Print Quality

• Adjusting the Print Darkness
• Adjusting the Print Speed

Adjusting the Product's Buzzer Volume

Adjusting the Head Pressure Balance

• Print Head Balance
• Head Pressure Setting
• Pressure Balance Setting

RFID Settings (RFID Models Only)

• Usable RFID Standards
• Configuring the Product to Encode Inlays
• Setting Write/Read Conditions Appropriate for RFID Tags
• Printing RFID Tag Errors
• RFID Error and Reset Timing
• External Signal (EXT) Interfaces When RFID Mode Is Enabled
• RFID Printing Tips

Configuring Optional Barcode Check Function

• Basic Specifications of the Barcode Check Function
• Setting Up the Barcode Checker
• Enabling the Barcode Check
• Restrictions for the Barcode Check Function

Initializing the Product

• Procedures for Initializing
• List of Initial Values